1 Introduction

CISCO Catalyst 2960 Series

# minicom -s

    | A -                             Port série : /dev/ttyUSB1             |
    | B - Emplacement du fichier de verrouillage : /var/lock                |
    | C -            Programme d'appel intérieur :                          |
    | D -            Programme d'appel extérieur :                          |
    | E -                      Débit/Parité/Bits : 9600 8N1                 |
    | F -              Contrôle de flux matériel : Non                      |
    | G -              Contrôle de flux logiciel : Non

# minicom and switch on the cisco:

> enble
# show arp
# show int FastEthernet0/8
# configure terminal

(config)#int range FastEthernet 0/1-7                                  
(config-if-range)# switchport mode access
(config-if-range)# switchport access vlan 199
(config-if-range)# do write
^Z

(config)# int GigabitEthernet 0/1
(config-if)# no switchport access vlan
(config-if)# switchport mode trunk
(config-if)# switchport trunk allowed vlan 40,199 

(config)#vlan 1
(config-vlan)#
(config)# exit

(config)#interface Vlan 40 
(config-if)# ip address 192.168.1.200 255.255.255.0
(config-if)#description private network NeCTAr

(config)#interface Vlan 199
(config-if)#ip address 134.158.155.234 255.255.248.0                                                                        
(config-if)#description network lab

# show interface

Vlan40 is up, line protocol is down                                               
  Description: private network NeCTAr                                           
  Internet address is 192.168.1.200/24      

Vlan199 is up, line protocol is down                                                  
  Description: network lab                                                      
  Internet address is 134.158.155.234/21     

# show run    
# write memory (idem que "do write" mais en mode de base (#))

Home

This document is also available in PDF and PostScript format.

2016-02-15

Contents

1 Introduction